How to active IPS on an ASA 5510

[dchavarria]

Hi,

How to activated IPS in an ASA 5510 and then to change de IP address that comes by default, thank you for your help.

David Chavarria.

[sawgupta]

Use the "session 1" command from ASA. It will open a IPS session. If this is the first time you are accessing IPS, it will open the setup wizard. Otherwise, you may simply issue "setup" command on IPS CLI.

In the setup wizard, you can configure the management IPS address.

http://www.cisco.com/en/US/docs/security/asa/asa84/asdm64/configuration_guide/modules_ips.html#wp1170445

Regards,

Sawan Gupta

[Todd Pula]

Here are a fiew VoDs that walk you through the process:

https://supportforums.cisco.com/docs/DOC-12233#comment-6554