Hi there,
I am new in Firewall.
I have a test ASA 5505 at home.
The DHCP IP address in my real home firewall is 192.168.1.x and as you are aware the default ip address in ASA is the same.
I have searched a lot to learn how to configure the ASA.
In the link below there is an instruction, it seems it is working for everybody except me. I followed the instruction up and the only change was assigning the IP address, which I chose something other than 192.168.1.x
But after the step of creating NAT, I do not have access to the internet.
http://www.firewall.cx/forum/10-firewall-filtering-idsips-a-security/32041-howto-basic-asa-5505-configuration.html
Also I followed the link below, but the revision of the ASDM in the instruction does not match with mine, so I was not lucky to figure the device.
http://www.youtube.com/watch?v=vFnXd3ttRk8
Now my questions:
1- How can I configre the ASA 5505 with an IP address different than 192.168.1.x (at home = no incoming static IP address = DHCP on subnet 192.168.1.x for the incomming internet)
I have installed ASDM 6.3 on my laptop (From work) but when I connect to the ASA it wants to install ASDM 5.7.
I tried to connect to the device through ASDM 6.3 and input the IP address 192.168.1.1
It takes for ever and it does not connect to the device
2- How can I connect to the device by ASDM 6.3 or any ASDM with higher version than the original of the device?
Thank you in advance for your time
