How to NAT L2L VPN with same networks on each side.

[dan hale]

Hi All, I have to create a L2L however, on site A I have network 192.168.11.0 /24 and at Site B I have network 192.168.11.0 /24.

Fortunatly Site B will be intiating the traffic and they only need to talk to one host that is in a differnt subnet at site A. The host

is 192.168.2.15.

My side is a Cisco 5510 ASA. I think the other side is a Cisco Interatged Service router not sure the module but, is capable of doing VPN's.

How can I accomplish this...what will by ACL's, NAT's, Cryptos look like?

Site A                                             Site B

192.168.11.0 /24 ----- Internet ----- 192.168.11.0 /24

192.168.2.15

Thanks in advanced,

Dan

[Maykol Rojas · Accepted solution]

Hi,

You can accomplish that by following the guide documented here:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080b37d0b.shtml

There is an specialized part of VPN on this CSC community, feel free to post any questions that you have over that section.

Cheers,

Mike