Re: How to power up IDSM-2

v.nastase · ‎03-21-2005

Hi

I have Cat6509 with IDSM-2 in PwdDown state.

How can I power up the blade ?

Thanks in advance for your help

a.arndt · ‎03-21-2005

I believe issuing a reset command to the IDSM-2 from the Catalyst’s CLI will do this.

Catalyst Software

To reset the IDSM-2 from the CLI, follow these steps:

Step 1 Log in to the console.

Step 2 Enter privileged mode:

Console> enable

Step 3 Reset the IDSM-2 to the application partition or the maintenance partition:

Console> (enable) reset module_number [hdd:1/cf:1]

Cisco IOS Software

To reset the IDSM-2 from the CLI, follow these steps:

Step 1 Log in to the console.

Step 2 Enter privileged mode:

Router# configure terminal

Step 3 Reset the IDSM-2:

Router# hw-module module module_number reset [hdd:1/cf:1]

I hope this helps,

Alex Arndt

v.nastase · ‎03-21-2005

I tried with:

sw# hw-module module 8 reset

but the response was

module 8 is operationally off (Module Failed SCP dnld)

a.arndt · ‎03-21-2005

Unfortunately, I don't have a lot of experience with this.

You have, IMHO, two options at this point:

1) Wait for an answer to your post from a more knowledgeable member of the forum (or Cisco); or,

2) Open a TAC case and get immediate support.

The choice is yours. Sorry I cannot be of any help...

Alex Arndt

marcabal · ‎03-21-2005

Cat OS: set module power up

Native IOS: power enable module