ā05-29-2019 12:21 PM - edited ā02-21-2020 09:10 AM
Hi all,
Does anyone know if the Firepower 4100 supports a CLI method of checking tranceiver details? I am trying to determine what model SFP is installed in an interface, but can't find this info for the life of me.
I have tried numerous things as well as Internet searches and haven't figured it out yet. At a minimum I would like to know the type of transceiver, but also the optical info as well if possible.
Here's what I believe I have tried so far:
scope chassis > show inventory
show eth-uplink expand detail
scope eth-uplink > scope fabric a > show interface # # detail
scope eth-uplink > scope fabric a > show port-channel
scope fabric-interconnect a > scope card # > show detail
Thanks!
Solved! Go to Solution.
ā08-09-2021 04:37 AM
Just adding this reply in case anybody comes across this thread as a result of a search.
Under "scope fabric-interconnect", use "show inventory expand detail".
That command will return full details of the installed transceiver(s).
ā06-14-2019 07:10 AM - edited ā06-14-2019 07:10 AM
Try the following from the chassis CLI it should have the information that you are looking for
connect fxos
show interface transceiver details
ā08-09-2021 04:37 AM
Just adding this reply in case anybody comes across this thread as a result of a search.
Under "scope fabric-interconnect", use "show inventory expand detail".
That command will return full details of the installed transceiver(s).
ā08-14-2021 09:23 AM
Transceiver and other chassis/hardware-related commands can be found in the Firepower eXtensible Operating System (FXOS) Technical FAQ.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: