09-07-2009 06:43 AM - edited 03-11-2019 09:13 AM
Hello experts,
I'm doing authentication on the firewall for HTTP and HTTPS traffic. It is working fine for the HTTP, but it does not work for HTTPS, do I require virtual http? even with that I was not getting the prompt, I was able to access directly... this is my configuration:
test(config)# sho run
ASA Version 8.0(3)
!
interface GigabitEthernet0/0
nameif outside
security-level 0
ip address 192.168.180.96 255.255.255.0
!
interface GigabitEthernet0/1
nameif inside
security-level 100
ip address 192.168.100.1 255.255.2
access-list aaa extended permit tcp any any eq www
access-list aaa extended permit tcp any any eq https
nat-control
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0
route outside 0.0.0.0 0.0.0.0 192.168.180.5 1
aaa authentication match aaa inside LOCAL
username test password xxx encrypted
09-07-2009 07:12 AM
Hi
Are talking about https for the asa it self? if so then put in http server enable
Kev
09-07-2009 11:06 PM
No need virtual http for https authentication as I know.
https also supportoted for proxy authentication as http
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: