Hi in our network we have implimented VSS withtwo Cisco 6509 -Eswitches. In these switch I have installed IDS module and following are my IDS configurations.
intrusion-detection switch 1 module 4 management-port access-vlan 21
intrusion-detection switch 2 module 4 management-port access-vlan 21
intrusion-detection switch 1 module 4 data-port 1 trunk allowed-vlan 27,31
intrusion-detection switch 2 module 4 data-port 1 trunk allowed-vlan 27,31
intrusion-detection switch 1 module 4 data-port 1 autostate include
intrusion-detection switch 2 module 4 data-port 1 autostate include
Whenever I am restarting any node of my VSS the last two lines of the IDS configuration disappears and i need to reenter this manually.
"intrusion-detection switch 1 module 4 data-port 1 autostate include
intrusion-detection switch 2 module 4 data-port 1 autostate include"
Following are my switch details.
Switch model : WS-C6509-E
SUP module : VS-S720-10G
IDS module details : WS-SVC-IDSM-2
IDS firmware : 7.2(1)
IDS software : 6.2(3)E4
I dont understand what causes this problem and during reboot of any VSS node why this configuration is not getting replicated to the othet node?
Please help me...