Import firepower config to FMC

[manvik]

guys this might be a running thread already.

I am using an FDM for sometime. Recently purchased FMC. Can I add FDM/FTD (firepower device) to FMC without loosing any FDM config.

Is there an option to import Firepower config to FMC.

[balaji.bandi]

check this thread may be helpful :

https://community.cisco.com/t5/network-security/from-fdm-to-fmc-conversion/td-p/4056118

[Marvin Rhoads]

Short answer: no.

[manvik]

thank you guys,

this doc gives a good method-https://www.theroutingtable.com/add-remote-firepower-firewall-to-firepower-management-center-new-process-with-nat/

[balaji.bandi]

sure if you looking to add FTD to FMC using documents