cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1093
Views
0
Helpful
3
Replies

IPS-4270-20 Power Down

Wemerson Luiz
Level 1
Level 1

Dear, Friends.

For unknown reason the IPS Power Down always in the same time.

How can I verify the temperature of the equipment?

How can I verify the Power Supply?

The only thing that I saw different is the Internal system health indicator was Flashing red.

Somebody Know How Can I fix this problem?

Regards

1 Accepted Solution

Accepted Solutions

Dustin Ralich
Cisco Employee
Cisco Employee

The IPS 4270-20 sensor appliance has a built-in Diagnostics Panel that you can check to help narrow the cause:

http://www.cisco.com/en/US/docs/security/ips/7.0/installation/guide/hw_installing_4270.html#wp40629

View solution in original post

3 Replies 3

Dustin Ralich
Cisco Employee
Cisco Employee

The IPS 4270-20 sensor appliance has a built-in Diagnostics Panel that you can check to help narrow the cause:

http://www.cisco.com/en/US/docs/security/ips/7.0/installation/guide/hw_installing_4270.html#wp40629

Dear Dustin,

Thanks for help me.

Regards,

Dustin any info on what to check , I have an IPS 4270- cant seem to get console access or connect to mgnt port.....  I remove the cover and On the lcd I get a two codes that flash     01   then 51   any help thanks   cant seem to find anything out there

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: