cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1225
Views
0
Helpful
2
Replies

Is there a similar entry to "management-interface inside" on FTD CDO

ABaker94985
Spotlight
Spotlight

The management system at our HQ reaches out to the inside interfaces of the branch firewalls through site-to-site VPN tunnels for both pings and SNMP, and on the firewalls running ASA firmware, we use "management-interface inside." Is there a similar command for the FTD/CDO? Is this a command that go in flex config? I've not been able to find documentation on how to get this inserted.

 

The system I'm currently working with is an ASA 5508-X running 6.6.1. The ACP is permitting this, but I'm also not sure if there is something on the control plane that needs to be opened up. Is there anything else I need to consider?

 

Thank you.

1 Accepted Solution

Accepted Solutions
2 Replies 2

Thanks for the super fast response. That's exactly what I was looking for. Take care.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card