We need to have one connection with less internet bandwidth assigned to it than all other other connections. Basically it is a separate conection from all others, incomming just from one switch port and separate VLAN
I know this can be done on the switch by limiting the bandwidth allocated to a port,
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# srr-queue bandwidth limit 80
however, is it possible to have the speed limited down, just before it goes to the internet, ie, on the ASA, rather than doing it on the switch?
The Cisco Secure Firewall and SecureX teams are looking for feedback from active Secure Firewall users who may or may not have already activated SecureX. Your responses will help us improve the Firepower experience in SecureX. Th...
Related documentsCisco ISE (Identity Services Engine) IPv6 features by release2.6ISE ManagementNetwork Time Protocol SupportDomain Name System SupportExternal RepositoriesAudit Logs and ReportsSimple Network Management ProtocolAccess Control Lists And Dyn...
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 126.96.36.199Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 188.8.131.52R1(config-ikev2-keyring-pee...