01-12-2015 04:59 AM - edited 02-21-2020 05:22 AM
Hello,
i need to manage an active/standby ASA CX configuration with PRSM Multidevice mode. Is it possible?
I read on documentation:
If the ASA is in multiple-context mode, you can still manage a CX module
But it seam to be possible only with single mode PRSM.
Anyone can confirm it?
01-12-2015 06:35 AM
I have managed Active/Standby ASA pairs in both single context and multiple context mode with PRSM multi-device mode.
I've only used PRSM to manage the CX modules - not the base ASAs.
01-14-2015 07:56 AM
Whit which IP address do you import the active/stanby ASA on PRSM multi-device? I tried using the CX management IP but the server doesn't import them even if the ping success.
With ASA management IP address a failure message appear.
01-14-2015 08:01 AM
The base ASA is managed using an inside interface. In my case it is a subinterface that's on the same subnet as PRSM - so there's no question of routing back from the ASA since it a connected subnet.
So I have the ASA subinterface I'm using for management on the same VLAN as the physical interface that's connected to the CX (hardware module in this case since it's a 5585-X). The PRSM VM is also on that subnet.
You could do it other ways as long as all the routing works out.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: