11-22-2012 06:26 AM - edited 03-11-2019 05:26 PM
Hi Folks,
Just want to check with you about memory utilization on the Asa 5510 ..
Free memory: 19%
Used Memory: 81%
Is this normal? Because we hade a problem this morning and the memory was at 100%..
Device Manager version 6.1(5) 57
Hardware: ASA5510-K8, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Any tips and tricks?
11-22-2012 06:58 AM
Hello Shane,
Open a TAC case as soon as you can so we can take the required outputs to decode what is going on, This is definetely not expected ( Because we hade a problem this morning and the memory was at 100%)
Regards,
Julio
11-22-2012 08:17 AM
Well i don't think its a huge problem, I think it was a spanning tree issue on the switches..
But for now the mem utilization is at 81%..
/Shane
11-22-2012 08:57 AM
Hello Shane,
Okay, good to know that,
Here are some facts about memory problems:
Here are some possible causes and resolutions for high memory utilization:
Regards,
11-23-2012 04:12 AM
Hey
Thanks for the info,
I have one more question, now the ASA is working fine, but one thing is a little off, the dmz interface is not working the way it suppose to. Clients are not reaching the servers on the DMZ interface Maybe it has something to do with that we hade a failover firewall that was On before..But probably not..
Also Syslog Messages in the ASDM, i see a bunch of
DENY ICMP revers path check from x.x.xx to x.x.x.x on interface dmz
DENY ICMP revers path check from x.x.xx to x.x.x.x on interface outside
Thanks again
Shane
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide