11-07-2015 05:20 AM - edited 03-11-2019 11:50 PM
Hi ,
kindly suggest the configuration URL for natting from outside to inside interface .
Regards
Arshad Ayub
11-07-2015 07:44 AM
Hello,
I think this document will help you. See "ASA Version 8.3 and Later" setting if you use ASA 8.3+ version.
NAT and PAT Statement Use on the Cisco Secure ASA Firewall Configuration Example
http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/15243-19.html#anc4
11-10-2015 07:57 AM
Hi Akira , Thanks for this ..
But i need dynamic NAT for outside to inside ...(CCIE TOPIC)
Regards
Arshad Ayub
11-10-2015 08:31 AM
Hi Arshad,
You could configure Outside nat. Use the link below :
http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/nat_dynamic.html#wp1079227
Outside nat is configured by using 'outside' keyword at the end ot nat statement. Use the above link and search for ' Outside NAT and Inside NAT Combined'.
Hope it helps.
Regards,
Akshay Rastogi
Remember to mark the answer as correct if it answers your queries or rate the helpful posts.
11-11-2015 02:36 AM
Hi Akshay ,
above link is very usefull for me .....
I got some configuration retaled to this, your suggstion is also very perfect for me .
Thanks you very much
Regards
Arshad Ayub
11-11-2015 03:09 AM
Hi Arshad,
You are welcome.
Regards,
Akshay Rastogi
Remember to mark the answer as correct or rate the helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide