cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

224
Views
0
Helpful
2
Replies
Highlighted
Beginner

NAT translation for each IP

Hello ,

 

I have a Firewall 5545 and i would like to take output for each NAT translation (Nat Table). Can i have some help on this please ?

I tried "show xlate" command but i have no output. Do you have any other idea ?

 

Thanks ,

George

 

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

Re: NAT translation for each IP

Hello,

 

If 'show xlate' does not throw any output then maybe there are no translations currently. You can check for static and dynamic translations by checking output of 'sh xlate type static' or 'sh xlate type dynamic' .

 

I checked in my environment and it works perfectly.

 

HTH
AJ

View solution in original post

2 REPLIES 2
Highlighted
Rising star

Re: NAT translation for each IP

Hello,

 

If 'show xlate' does not throw any output then maybe there are no translations currently. You can check for static and dynamic translations by checking output of 'sh xlate type static' or 'sh xlate type dynamic' .

 

I checked in my environment and it works perfectly.

 

HTH
AJ

View solution in original post

Highlighted
Participant

Re: NAT translation for each IP

sh xlate should allow you to see all active nat translations through the asa.

you could try sh conn to see all active connections through the asa.

hope that helps!

azam