NAT within FTD

[scshockley03]

I am trying to view the current NAT translations in FTD and can only get information about outside addresses. Is there a way to see the corresponding inside addresses similar to information that would be displayed with the "show ip nat translations" command on a router? Thanks in advance for any feedback.

[balaji.bandi]

Are you managing FTD using FDM or FMC 

check below guide :

https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/212702-configure-and-verify-nat-on-ftd.html

[Rob Ingram]

@scshockley03 use the command "show xlate"

EDIT: for typo.

[rhingel]

I am sure Rob meant to say show xlate but with a small typo.