cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
5
Helpful
6
Replies

newbie question FPR 1010 FTD

Newbie question trying to learn more on FPR setup.

I have a setup looking like this
ISP -> FPR 1010 FTD (192.168.10.1) -> UDM PRO gateway (10.90.22.1) -> Unifi switch

When i turn on my NAT rule on my UDM for my Vlan 22 (10.90.22.0/24) im no longer able to connect to my FPR on the its IP.
I simple cant reach it any longer, tracert shows that i exit via the GW for the Vlan then it dies.

On my UDM for all Vlans i've created a Source NAT to point to the FPR 192.168.10.1
(Interface=WAN port, Translated IP=10.90.22.0/24 Source=10.90.22.0/24, Destination=192.168.10.1)
i have on the FPR create the 2 Vlans prensent on the UDM 10.90.22.0, 10.90.33.0.

I can't figure out what is wrong in my setup and why im not able to access the FPR, i've tried to create allow policy for the 10.90.22.0. management access is also allowed currently on all subnets 

1 Accepted Solution

Accepted Solutions