12-16-2017 01:57 AM - edited 02-21-2020 06:57 AM
I have installed FMC and registered 2 SFR module successful.
I have also configured ASA to send traffic to SFR for traffic analysis but still I am not able to see any traffic on FMC being analyzed.
Below is the ASA config :
ASA/act# show service-policy sfr
Global policy:
Service-policy: global_policy
Class-map: global-class-sfr
SFR: card status Up, mode fail-open
packet input 3769932114, packet output 3770123526, drop 96788, reset-drop 0
ASA/act#
12-16-2017 08:36 AM
hi
i had the same issue, it solved once i enabled NTP time synchronization of FTD devices via FMC.
12-16-2017 09:00 AM
Hi,
Yes, thought so but with NTP or manual setup still no success. I am not getting any data on dashboard.
12-16-2017 06:06 PM
By default connections are not logged.
Have you configured any access control policies with the "log" option turned on and/or specified the default intrusion policy to log connections?
12-17-2017 05:27 AM
Hi Marvin,
I have set Intrusion Policy to "Balanced security and connectivity" and logging with "Log at end connection" for Allow traffic and "log at beginning of connection".
12-17-2017 06:04 PM
Can you share a screen shot of your access control policy page?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide