PAT not working

[marcolanni]

Hi All,

Simple problem i have setup a NAT Rule as follows

static (Inside,Outside) tcp WEB_REMOTE_ACCESS_EXT 2081 JENKINS https netmask 255.255.255.255 

It wont let me use port 2081 to get to that server if i change it to 443 it works fine. I have tried changing it to various custom ports but no help

Any ideas as i dont think there is much more i need to configure to get it working

Hope you can help

Marco

[Julio Carvajal]

Hello Marco,

Is the traffic reaching the  WEB_REMOTE_ACCESS_EXT on port 2081, are you seeing the packets reaching the ASA???

Have you place the ACL pointing to that IP address on port 2081

Regards,

Julio

Cisco Security Engineer

Please rate all the helpful posts