04-27-2006 04:26 AM - edited 02-21-2020 12:51 AM
I amtrying to know that can i use pix 506e in single armed mode.
I have to place a pix and the only solution to it is this only
Thanks
Chetan
05-02-2006 11:58 PM
Hello,
When you say single armed mode I'm assuming that you mean a router on a stick where all the traffic comes to and leaves out of a single interface. If this is what your wanting to do then no a 506e with 6.x and below does not have the ability to let traffic that has arrived on an interface leave the same interface.
Patrick
Please rate any posts that are helpful.
05-02-2006 11:58 PM
Hello,
When you say single armed mode I'm assuming that you mean a router on a stick where all the traffic comes to and leaves out of a single interface. If this is what your wanting to do then no a 506e with 6.x and below does not have the ability to let traffic that has arrived on an interface leave the same interface.
Patrick
Please rate any posts that are helpful.
05-03-2006 06:56 AM
I see no Reason to to this unless u absolutly have only one interface available on your switch.
since release 6.3.(4) u are able to configure 1 extra vlan interface on the 506e.
so u could trunk the switch with the pix en firewall between the two vlans.
Troughput for both vlans is ofcourse Limited by the fysical interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: