cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
529
Views
0
Helpful
5
Replies

Pix 515 pat stops working?

lakn
Level 1
Level 1

Greetings.

I have a pix515 that is showing PAT entries in show xlate for a whole bunch of customers. But only some of the segments gain access to the outside. Some specifik segments fail to access even though they get PATéd.

I have made sure that permit ip any any is configured so that the acl is not stopping access. And I have checked routning. I am able to ping into the internal network and access the clients that way.

as an example:

10.125.24.x is not able to get out.

10.125.80.x is

thanx. Lars

5 Replies 5

lakn
Level 1
Level 1

added comment:

I took one of the clients who did not have access through the PAT and did a static on it. Wham, and it was on the net.

Hello,

Try doing a clear xlate.

I don't see anything that jumps out at me right this moment.

Is this still a problem of did you figure something out yet?

Patrick

So sorry for not replying faster (been very busy)..

But it was not the pix. It just seemed so.

Our ISP have started to allocate /29´s to other customers from our /25!

so as the customers adverticed their new net, our part went away to them and not back to us.

So )/(¤%&"¤%&"¤%/#%#&/%& our ISP! Being worked on as I write this..

Thanx for your reply.

-- Lars

That happens pretty often, if you ref. to TDC :-)

Martin

UNI-C.dk

ROFL!!

And yes.. TDC rulez..

Review Cisco Networking for a $25 gift card