cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1075
Views
0
Helpful
2
Replies

PIX 520 Failover

mowtnman
Level 1
Level 1

I have 2 PIX 520's setup with failover between the 2. If you unplug an interface that is in a switch or hub this will cause failover between the two... Failovers kill connections. I need to move the connections into a new switch without causing a failover between the 2 devices. Is there a way to do this? The interfaces I need to move are neither the inside or outside interface of the Pix...

Thanks in advance.

2 Replies 2

r-simpson
Level 3
Level 3

You would have to enable stateful failover to maintain the connection states during the failover event.