cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

284
Views
0
Helpful
2
Replies
Rejohn Cuares
Enthusiast

PIX/ASA Failover Design

Hi!

Are there anybody here tried to setup A/A failover or A/S Failover with DMZ support?

I read the docu found here

http://cco.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/failover.htm#40447

and it seems DMZ support is not supported. correct me if im wrong. I attached the network topology.

Need your comments. Thank you!

Please rate replies and mark question as "answered" if applicable.
2 REPLIES 2
dmooreami
Participant

I can't figure out if I have to dedicate an interface on the ASA JUST for failover/stateful traffic.

In order to implement failover either A/A or A/S you must dedicate 1 port for failover.

Please rate replies and mark question as "answered" if applicable.
Content for Community-Ad