PIX/ASA Failover Design

[Rejohn Cuares]

Hi!

Are there anybody here tried to setup A/A failover or A/S Failover with DMZ support?

I read the docu found here

http://cco.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/failover.htm#40447

and it seems DMZ support is not supported. correct me if im wrong. I attached the network topology.

Need your comments. Thank you!

[dmooreami]

I can't figure out if I have to dedicate an interface on the ASA JUST for failover/stateful traffic.

[Rejohn Cuares]

In order to implement failover either A/A or A/S you must dedicate 1 port for failover.