I installed a pix 506 to protect a single server inside a network the network is divided into 2 nets:
the 1st net has an IP adress of 131.107.0.0/24
the second network has an ip of 10.3.1.0 255.255.255.248
the pix is protecting ip 10.3.1.3 255.255.255.248
the nat inside the pix is the following:
global (outside) 1 10.3.1.3 netmask 255.255.255.248
nat (inside) 1 10.3.1.0 255.255.255.248 0 0
the problem is when we change the global outside address to 10.3.1.5-8 we can access the outside interface but we do not access it with the 10.3.1.3
even when we change the ip address of the protrcted server it still doesn't work; i need to keep this address because i have a VPN that forwards information to that specific address and to a specific port.
anyhelp with this problem?