03-31-2005 10:30 AM - edited 02-21-2020 12:02 AM
Hello,
I have VPN access through my PIX from the outside. I have a restricted license. How can I tell how many concurrent VPN connections am I allowed. The config indicates only two ip address available for VPN connections, but not sure if it is my limit. If allowed more than two how can I change the vpn ip pool and password.Here is the "sh ver" output:
Hardware: PIX-515, 32 MB RAM, CPU Pentium 200 MHz
Flash i28F640J5 @ 0x300, 16MB
BIOS Flash AT29C257 @ 0xfffd8000, 32KB
0: ethernet0: address is 0004.9ad0.f48a, irq 11
1: ethernet1: address is 0004.9ad0.f48b, irq 10
2: ethernet2: address is 0002.b3c1.73bb, irq 9
Licensed Features:
Failover: Disabled
VPN-DES: Enabled
VPN-3DES-AES: Disabled
Maximum Physical Interfaces: 3
Maximum Interfaces: 5
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
This PIX has a Restricted (R) license.
03-31-2005 10:45 AM
The restricted license has the same vpn limitations as the UR for the 515 - that of the hardware, which is 2000 concurrent tunnels. I tend to doubt a 515 could actually support that many, but that is the only limit
03-31-2005 12:07 PM
See this data sheet, but there is no diffrence with UR and R License.
sincerely
Patrick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide