Hi There,
I was implementing a Pix 506E ver 6.3(3) the other night and ran into a few challenges that I was hoping someone could help me with.
To set up the topology: we have two T-1s coming in that land on a Cisco 25XX and then hand off via E0 to the PIX. Both T-1s are private lines that directly connect to customers routers. Networks 10.29.0.0 and 10.31.0.0. Inside the PIX we are running 192 and 172 networks and have disabled NAT&PAT due to the need for each others hosts to directly connect between the different companies servers for billing purposes etc. For my route statements I only had the default route outside and was not able to have the hosts get to the outside networks but after adding a command of route outside 10.0.0.0 255.0.0.0 172.20.50.1<--E0 IP on router connected to E0 of PIX I was able to get to those remote networks. Why did I have to put in any route commands for traffic going out of the PIX...is this because I've turned of NAT?
OK second question. I want all of my hosts to be able to go out of the PIX without natting them so then I just need to put in these commands correct?
static (inside,outside) 172.20.0.0 172.20.0.0 netmask 255.255.0.0 0 0
static (inside,outside) 192.0.0.0 192.0.0.0 netmask 255.0.0.0 0 0
Any feedback is always appreciated. thanks.
