04-28-2013 04:49 AM - last edited on 03-25-2019 05:20 PM by ciscomoderator
Hello there,
We have Active/Standy ASA units with SSM-20 IPS modules. Everytime the Primary ASA unit gets failed and a switchover is triggered. As a result, Secondary becomes active and Primary becomes standy failed.
I upgraded IPS firmware to the latest one, I then changed both Primary ASA unit along with IPS module. But the issue still persists.
I have provided proper earth and power.
Thanks in advance.
04-29-2013 04:37 PM
When you changed the IPS modules, did the problem follow the original IPS module? If so, you may have a bad module.
05-01-2013 11:18 AM
Hi,
To start with, can you paste the following from the two ASA's:
- show failover history
- show failover
- show module 1 detail
- show run failover
- Syslogs from the instant when failover occured if available.
I will review these and let you know if more outputs are needed to figure out the root cause.
-
Sourav
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide