cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
978
Views
0
Helpful
4
Replies

Protecting a public IP server thats not NATTED

Kudetauk77
Level 1
Level 1

Hi All 

 

I have been given requirements by out it staff that they need to configure a server with a public IP address , This would not have a NAT , Can any one explain if its possible to protect this server behind our firewall ? As this will be on the public facing Vlan I am not sure I can 

 

Thanks 

 

Craig 

4 Replies 4

gbekmezi-DD
Level 5
Level 5
By default, the firewall will not permit traffic from the outside to an inside network so the server will be protected unless you explicitly permit traffic to it. Additionally, if you are using FTD, you will be able to make use of the IPS to detect and potentially stop other malicious activity.

Hi Thanks for the input , 

 

But the public IP is already outside the firewall on the public facing Vlan ( same vlan as the outside interface of the firewall ) then its already in front as its not natted. So traffic would hit it directly ....I think 

Do you consider DMZ ?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

mkazam001
Level 3
Level 3

Here's a generic config for allowing access from the Internet to a DMZ web server on port 80:

object network WEBSVR-EXT
 host 100.1.1.10
object network websvr-int
 host 172.16.0.10
nat (dmz,outside) static WEBSVR-EXT service tcp 80 80
access-list OUTSIDE-IN ext permit tcp any object websvr-int eq 80

Access to the server is controlled on the last line above.

Useful to run packet tracer to verify config too.

Hope that helps!

Azam

Review Cisco Networking for a $25 gift card