01-11-2007 05:23 AM - edited 03-11-2019 02:18 AM
My secondary 7600-FWSM unit was reloaded and after that I have not been able to turn the failover on!
Please advice.
Thanks Kevin
Here is the error:
sh failover
Failover Off (pseudo-Standby)
Failover unit Secondary
Failover LAN Interface failover Vlan 1083
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 15 seconds
Interface Policy 1
Monitored Interfaces 7 of 250 maximum
failover replication http
CORE-FWSM-1# conf t
CORE-FWSM-1(config)# failover
CORE-FWSM-1(config)#
Detected an Active mate
Vlan configuration mismatch
Failover will be disabled
Solved! Go to Solution.
01-11-2007 06:01 AM
Vlan configuration mismatch sounds like you may have allocated some vlans to one of your firewalls that you haven't to the other.
In your 6500 config on both switches check the line
"firewall vlan-group x "vlan numbers"
Make sure they both list exactly the same vlan numbers.
HTH
01-11-2007 06:01 AM
Vlan configuration mismatch sounds like you may have allocated some vlans to one of your firewalls that you haven't to the other.
In your 6500 config on both switches check the line
"firewall vlan-group x "vlan numbers"
Make sure they both list exactly the same vlan numbers.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide