When we use Aspera, it maxes out our bandwidth and we cannot do anything else while the download is going on.
3220ASA1# sh conn add 192.168.0.105 prot udp
110 in use, 509 most used
UDP outside 153.7.233.153:33001 inside 192.168.0.105:60064, idle 0:00:00, bytes 573048376, flags -
I want to rate-limit the UDP port 33001 that aspera uses, here is that part of my config. I applied the QoS to both the inside and outside interface for port 33001.
ASA Version 8.6(1)
access-list outside_mpc extended permit udp any any eq 33001
access-list inside_mpc_1 extended permit udp any any eq 33001
!
class-map inside-class
match access-list inside_mpc_1
class-map outside-class
match access-list outside_mpc
!
policy-map outside-policy
class outside-class
police input 100000 1500
police output 100000 1500
policy-map inside-policy
class httptraffic
inspect http http_inspection_policy
class inside-class
police input 100000 1500
police output 100000 1500
!
service-policy outside-policy interface outside
service-policy inside-policy interface inside
Do I have this wrong? The ASDM is still showing traffic as much higher than the 100kbps I want to limit to.
