Re image FPR1150 from FTD to ASA

[KayaaKashyap]

Hi,

Do we have migration tool for re-image FPR from FTD to ASA?

Is there any issue with supported OS?

what are the prerequisite?

[Rob Ingram · Accepted solution]

@KayaaKashyap You could probably use CDO https://www.cisco.com/c/en/us/products/collateral/security/defense-orchestrator/datasheet-c78-736847.html the FMT only works from ASA to FTD, not from FTD to ASA.

Here is the reimage guide - https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/reimage/asa-ftd-reimage.html

No issue with running either ASA or FTD software on the FPR hardware, make sure you install the latest recommended version - 9.20.3 https://software.cisco.com/download/home/286323330/type/280775065/release/9.20.3%20Interim

[KayaaKashyap]

Thanks for quick help.

FMT is Firepower migration tool? 

So in this case we need to remove all config from FTD and re-configure on ASA?

is my understanding correct?

Additionally, we are managing Firepower devices via FMC. Can we take backup from FMC and configure on ASA? 

[Rob Ingram · Accepted solution]

@KayaaKashyap yes, FMT = Firepower Migration Tool.

De-register the FTD from the FMC, then re-image the FPR hardware (using the guide above) and configure the ASA from scratch.