12-11-2019 12:07 PM - edited 02-21-2020 09:45 AM
I recently did an upgrade on an sfr on 5545 with Firepower Services from 6.2.0 to 6.4.0. The upgrade took a little more than an hour and everything thing came up on the sfr module ok after the reboot. Looking at it through the FMC, everything seems fine and up to the correct level of code, however the task on the FMC shows as failed. Has anyone run into it where the task on the FMC shows as failed, but the upgrade on the sensor did take ok ?
My next step is to patch to 6.4.0.4. The readiness check runs fine.
Thanks!
12-11-2019 03:26 PM
what version if your FMC ? it should be same or above version the one you mananging device
example : if SFR 6.4 / FMC should be 6.4 or 6.5 ?
12-12-2019 04:57 AM
FMC is on 6.4.0.4. So the FMC is on a higher version than the sfr sensor.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: