I need some documentation/examples of how to setup the following routing.
I have a PIX501 and I want to setup 2 vpn tunnels. Both tunnels will take different paths (frame relay network & verizon wireless data network) to get to the same VPN3000 Concentrator.
The traffic on the inside interface of the 501 needs to be able to take either tunnel to get to the remote destination (a network attached to the VPN3000). Not neccasarily load-balanced but a backup type scenario. Is this something I can use static routes for or would OSPF be better? How do you setup the VPN3000? Is there a better option?
