cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
406
Views
0
Helpful
3
Replies

Same Vlan on Multiple Subinterfaces Cisco ASA 5506-x

thom784e
Level 1
Level 1

Hello.

i'm trying to setup some subinterfaces the following way

Interface GigabitEthernet1/7.2
Vlan 2
192.168.2.1
Interface GigabitEthernet 1/8.2
Vlan 2
192.168.2.1

how ever it doesn't allow me to put vlan 2 on the 1/8.2 subinterface 
"ERROR: Vlan 2 exists in the global vlans table"

I am trying to setup the sub interfaces as gateways for the users/machines on each vlan.

Port 1/7 is linked to switch-01 and port 1/8 is linked to switch-02

now i do realize that i probably cannot have 192.168.2.1 as the IP on 2 subinterfaces either, but i am not sure how to properly do the setup otherwise so i will figure that issue out at a later point

MicrosoftTeams-image.png

i also plan on doing a HA (active/standby) with FW01 as master to help with redundancy.
if anything else appears odd and you have feedback i highly appriciate it  

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

You need to run HSRP depends on the requirement if this configuration you apply in the switch ?

Also i expecte ASA  FW Active /Standby config - please confirm ?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

yes, it will be an active/standby config.

the switches are L2 and will not have a lot configured on them.

we have since then found out that it is not possible to do HSRP on cisco asa 5506-x and we have decided to place 2 routers between the L2 switches and the firewalls

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card