cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
16792
Views
0
Helpful
3
Replies

Show active TCP connections in ASA 5520

bstockslager
Level 1
Level 1

I'm trying to figure out how many active TCP sessions my ASA has but having a hard time finding this information.  When I do "show conn count" from the CLI it shows what I'm guessing is a sum of both TCP and UDP.  Is there any way to get just the TCP connections?

3 Replies 3

Julio Carvajal
VIP Alumni
VIP Alumni

sh conn detail protocol tcp

Regards

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

This output shows the same number as if I were to enter 'show conn count' or "show conn detail protocol udp"

Hello Blake,

The number will be the same ( as it's the same output of the show conn count) but the connections reflected there are only TCP connections)

So if you do not want to manually go one by one counting the amount of TCP connections I would consider using Netflow,

I do not know any CLI command for the number of the TCP connections, it would be an aggregate of both UDP/TCP

Regards

Remember to rate all of the helpful posts, that is as important as a thanks

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Review Cisco Networking for a $25 gift card