Solved: Re: Simulate traffic in FMC

Me And You · ‎11-05-2021

Hi,

When using the ASDM its possible to simulate a traffic flow and it shows you all the rules it hits.

Is this also possible in the FMC WebGUI ?

Regards,

M&Y

Marius Gunnerud · ‎11-05-2021

Yes this is possible. Go to the following path:

Devices > Device Management and click the Troubleshoot icon next to the device you want to do the packet-tracer on. On the page that comes up click Advanced Troubleshooting. Here you can do the Packet-tracer, packet capture, etc.

Troubleshoot icon looks like this:

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

Marius Gunnerud · ‎11-05-2021

Yes this is possible. Go to the following path:

Devices > Device Management and click the Troubleshoot icon next to the device you want to do the packet-tracer on. On the page that comes up click Advanced Troubleshooting. Here you can do the Packet-tracer, packet capture, etc.

Troubleshoot icon looks like this:

--
Please remember to select a correct answer and rate helpful posts

C Garstka · ‎12-17-2021

FYI- if anyone has upgraded to 7.0.1, you instead have to click the 3 dots next to edit icon on that page to access troubleshooting. This too me way too long to find.

rcullum · ‎11-05-2021

Yes, in FMC, go to the Device Management, select troubleshoot on the device you want to check the rules on. Go to Advanced Troubleshooting. You can run packet tracer from there.