I am migrating ASA to FTD (FP 2100) and I am seeing that FP 2100 has two option/places to configure SNMP.
Option 1 in Devices > Plataform Settings as all other Firepower Devices.
Option 2 in Devices > Device Mangement exclusive to FP2100 series.
I am watching that Option 1 is the option to monitoring the firewall application, like data interfaces for example. In this option we must choose a security zone for monitoring, so I can´t choose management interface(used to FMC communication) for this purpose.
Option 2 is to monitoring the linux system inside the chassis. In this option I can choose the management interface for monitoring, but in this case I can´t monitor firewall application, like data interfaces for example.
I would like to know if my understanding is correct and if Cisco plans to unify SNMP management for Firepower appliances.
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 220.127.116.11Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 18.104.22.168R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...