cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
1
Replies

SRP541W advanced Firewall

labellepeter
Level 1
Level 1

HI. I have a SRP541W Router. we are getting alot of SIP attackes on port 5060.  

We have port 5060 forwarded to our PBX internaly.

I would like to configure the firewall so that only specific IP addresses are alowed through everything else is blocked.

I also dont want to block out IPsec traffic.

What would I need to enter in the chart below?

Rule Name:
Status: Enabled  Disabled
Interface:IN Interface(WAN):  Out Interface(LAN): 

Source IP Address: . . .
Source Subnet Mask: . . .
Destination IP Address: . . .
Destination Subnet Mask: . . .
Protocol:
Source Port: to
Destination Port: to
Action:

Schedule  Everyday   Sun   Mon   Tue   Wed   Thu   Fri   Sat
Times:24 Hours Range
1 Reply 1

jdiaz00011
Level 1
Level 1

I'm wondering if it was resolved. I have the same issue, i'm getting millions of attempt registration over 5060. I even setup a fw rule to block traffic from that source but it's still getting in. Is it that port forwarding takes precedence over fw rules??

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: