SSH access to firepower 1010 via loopback

[andreas.fuchs]

Hello guys,
we try to access a firepower 1010 (remote office) from our headquater over an ipsec tunnel via ssh.
Therefore we configured a loopback interface, which is part of the routing over the vpn, and this loopback is pingeable.
Somehow we are not able to get ssh running...
Any ideas what we need to enable to get ssh access to loopback running?
Thanks

[Marvin Rhoads]

It's not supported (on 7.3). "... loopback interfaces cannot be used for management features like AAA, SSH, Syslog, etc., they can only be used for VTI tunnels."

https://secure.cisco.com/secure-firewall/v7.3/docs/loopback-interface

As @Rob Ingram notes, release 7.4 adds ssh and other support.

(edited to reflect Rob's information)

[Rob Ingram]

From 7.4 - "You can now use loopback interfaces for AAA, BGP, DNS, HTTP, ICMP, IPsec flow offload, NetFlow, SNMP, SSH, and syslog" https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/roadmap/management-center-new-features-by-release.html

[MHM Cisco World]

are config config SSH in loop back via FMC ?
MHM