08-12-2009 06:43 AM - edited 02-21-2020 03:37 AM
Following the steps in:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00809f0d75.shtml#svg to configure SBL (ASDM), when I try to assign the XML profile to the group policy (step 11), I hit OK after choosing the XML file and it doesn't take. Just comes back with the "Add SSL VPN Client Profiles" dialog.
I used the XML file provided with the AnyConnect client and just changed the host settings, so the syntax should be right.
Any other suggestions?
08-12-2009 11:11 AM
You can validate the the xml schema at this site:
08-12-2009 11:18 AM
Thanks for the link. Ran it, all good.
Well formed: VALID
Schema validation: VALID
Now what? Is there a setting somewhere I missed? I followed the instructions.
08-12-2009 11:24 AM
what version of ASA and asdm are u using?
what happens if you use cli instead?
08-12-2009 11:32 AM
ASA 8.2(1)
ASDM 6.2(1)
I'm not the most versed in CLI so I am not totally sure of the right commands. When I followed the examples in the guide, I kept getting an invalid error in step 3 "svc profiles NAME disk0:/..." The indicator was showing under the NAME.
08-17-2009 01:50 PM
Anyone? Anything?
Bump.
07-13-2010 04:00 PM
+1 here. I am using ASA code 8.2(2) and ASDM 6.3(1). When editing the group policy, in the "SSL VPN Client" section, I change the "Client Profile to Download" from "-- None --" to one of my client profiles and click 'OK.' The 'Apply' button does not become clickable, and when I re-open the group policy for editing, the setting is back to None.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: