I need to get to an IP address on the other side of my Cisco ASA5555-X running 9.5.
Here's the important info (IPs obfuscated for obvious reasons):
I just cannot get my head round this one, basically I'm trying to get a basic NAT done, followed by a Source IP overwrite.
My initial attempt:
nat (inside,outside) source dynamic any interface destination static ext-map ext-map
...but that clearly misses the step where I translate int-map to ext-map. Can I even do this in 1 line of config??
object network OBJ-10.92.200.1
subnet 10.92.200.1 255.255.255.255
nat (inside,outside) source static any OBJ-126.96.36.199 destination static OBJ-10.92.200.1 OBJ-10.92.200.1
PS: Please don't forget to rate and mark as correct answer if this answered your question
I've resolved it:
object network int-map
object network ext-map
nat (inside,outside) source dynamic any interface destination static int-map ext-map
Very happy :)