Ok thats it. I am now 6 hours overtime in the office and i cannot get it to work.
I have this:
SG-BN001#sh zone security
Description: System defined zone
I have in the DMZ a Server. I want to access Port 8080 and Port 8443
I cant get it to work!
i have some other servers in the DMZ working with port forwarding
I use CCP -> i create rule on the OUT to DMZ Zone.
I use an object group, add this server, create custom ports for it add them and... no it isnt working!
Even when i allow IP for ALL DMZ Machine, i can only connect to port 8080. I never could connect ever to the second port the same time.
is it me? am i too stupid?
Using 2800x with 12.4
Solved! Go to Solution.
Does your NAT config look ok? for port 8443 to this server in the dmz.
Unfortunatley is section of the config that you posted is not enough to find out what might be going on.
ip inspect log drop
then try the connection and see what the logs says.
Hmm i did but my connection doesnt show up.
well i just added IP to inspect ANY ANY on the OUT - TO - DMZ ZONE
then 8080 is working
i cant understand this
my dmz interfaces are NAT INSIDE
but removing NAT doesnt change anything
no translation. also when i try 8081 8082 etc this is ALSO not working!
8080 is the only one that works..
Well thanks for your help kusan..... actually i fixed it.
THe Problem was i think that there was no access-group on the interfaces
i made access lists ip any any and applied them to the interfaces
AFTER THAT everything worked like i configured it in CCP
i have no idea why.. but now its working!