cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1234
Views
5
Helpful
4
Replies

Timezone for Firepower Services Module

fatalXerror
Level 5
Level 5

Hi Guys,

I am configuring a Firepower service module using the ASDM and I am using FP 6.4 version. I noticed that I cannot change the timezone of my Firepower module using the ASDM as it is default in "New York". Do you have any workaround for this issue?

Thanks

4 Replies 4

You could try the following work-around.  I unfortunately do not have an ASA with firepower module to test on at the moment.

Workaround:
Change the System Policy->Time Synchronization setting to manual mode, deploy the new System Policy, then set the timezone in the Local->Configuration->Time settings. Then, go back to your System Policy and change back to NTP mode (you'll have to re-enter your NTP server info) and deploy the new System Policy.

 

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuu10347/?rfs=iqvred

--
Please remember to select a correct answer and rate helpful posts

Hi @Marius Gunnerud, I tried that multiple times already and I even tried to re-image the module but when I change the time to manual, I cannot see the change time-zone option which is a bit weird.

Have any idea?

Thanks

Have a look at the solution here, might be a possible solution.

https://www.petenetlive.com/KB/Article/0001363

--
Please remember to select a correct answer and rate helpful posts

Hi @Marius Gunnerud , I tried this way as well but with no luck.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: