Unable to apply Secure shell setting to Management Interface.

[SurajS]

Hello Team,

We want to apply secure shell setting to our management interface to access SSH of FTD from management subnetwork only. But we can apply this settings inside or outside or DMZ interface only. Management interface not seen.

Primary Management IP of FTD: 10.101.30.X

Secondary Management IP of FTD: 10.101.30.X

Management subnet:10.102.13.0/24 from where we want allow access only.

FTD  integrated FMC with 10.101.30.X IP.

[Marvin Rhoads · Accepted solution]

The platform setting only applies to data plane interfaces. For the management interface you need to use a cli command from the FTD device itself.

Cisco Firepower Extensible Operating System (FX-OS) v2.10.1 (build 159)
Cisco Firepower Threat Defense for VMware v7.0.0 (build 94)

> 
> configure ssh-access-list 
  Arguments  Comma-separated list of CIDRs
  <cr>       

[SurajS]

Thank You ....!