After a long period of pretty stable operation, we have been experiencing semi-random outages for our WAN and after a brief suspicion of the external network connection are fairly certain our Firepower is actually the cause of the outage and just determined that it has in fact been rebooting itself. It appears to happen after about 2 days of operation. The web interface shows very little useful so getting more familiar with CLI. A few questions
1) what is the best way to determine cause of reboot or symptoms? (I have only seen uptime so far and it's short enough to explain the outage)
2) any ideas what might cause that pattern (the reboots are almost exactly (not quite)) 2 days apart so far, so it looks semi systematic.. Otherwise device looks happy - low cpu, plenty of disk space, not terribly loaded. Any thoughts appreciated and I suspect I'm about to get a crash course in the cli commands which is fine
Stealthwatch Enterprise can be leveraged to monitor vulnerable devices, and alert on potential exploitation by bad actors looking to exploit Ripple20 and other potential vulnerabilities.
Note that the concepts and procedures outlined here can be used for...
The following is useful to those entities interested in monitoring appropriate usage of Cisco WebEx resources within their environments, as well as those interested in tracking additional metrics around usage of the WebEx service.
The relevant supporting...
I'm using AMP, and when I activated the SecureX Ribbon, I mistakenly used the wrong account to connect to SecureX. Now my SecureX Ribbon is connected to the wrong account. How do I fix it?
You can clear the SecureX Authorizatio...
I'm using Umbrella, and when I activated the Ribbon, I mistakenly used the wrong account to connect to SecureX. Now my SecureX Ribbon is connected to the wrong account. How do I fix it?
You can clear the SecureX Authorization for t...
Hi, I saw certain endpoint running state is Unauthorized, UZ. Therefore I check in ISE found some details which I not sure related to endpoint being UZ or not , which is Invalid username or password under context endpoint. I do see the cert...