10-16-2020 03:43 AM
Hi
Could You please answer can I upgrade FTDv (virtual) to version 6.5.0.4 if I have FMC on version 6.5.0.2?
Solved! Go to Solution.
10-16-2020 04:10 AM
Yes, I don't see why not. The name of the patch is misleading, there is no 6.5.0.3 (it was removed from CCO) - so that Hotfix D is applicable to FTD 6.5.0.2.
10-16-2020 04:17 AM
That's correct, the FMC must run same or newer version than the managed FTDs.
10-16-2020 03:51 AM
No, you need to upgrade FMC to 6.5.0.4 before you upgrade the FTD.
10-16-2020 04:00 AM
Thanks Rob
If I upgrade FTD to version 6.5.0.2 as it is on the FMC can I also install hotfix for version 6.5.0.2 but named Cisco_FTD_Hotfix_D-6.5.0.3-3.sh.REL.tar?
10-16-2020 04:10 AM
Yes, I don't see why not. The name of the patch is misleading, there is no 6.5.0.3 (it was removed from CCO) - so that Hotfix D is applicable to FTD 6.5.0.2.
10-16-2020 03:57 AM
best approach is FMC and FTD, check the compatability matrix before upgrade.
make sure you have offload backup config -(to be safe)
10-16-2020 04:12 AM
Hi Balaji
In matrix there is no info about 6.5.0.x. There is info that
Version 6.5.0.x devices | require| Version 6.5.0 FMC
but also
An FMC must run the same or newer version as its managed devices.
10-16-2020 04:17 AM
That's correct, the FMC must run same or newer version than the managed FTDs.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: