I have two old 515 pix firewalls and would like to upgrade them with the earliest software version. Actually when I give a "sh ver" in each, I get this information, but I`m not sure how to read how much flash it has. Also if I need a flash upgrade, would like to have flash part number.
Thanks for your help!
This is information I receive:
FIRST PIX:
PIX Version 4.4(1)
Compiled on Tue 18-May-99 16:34 by pixbuild
PIX BIOS (4.0) #0: Tue May 18 16:29:54 PDT 1999
pixfirewall up 7 secs
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash strata @ base 0x300
0: ethernet0: address is 0050.54ff.2d3e, irq 10
1: ethernet1: address is 0050.54ff.2d3f, irq 7
Licensed Options:
Failover: Enabled
IPSec: Disabled
Ports allowed: 6
SECOND PIX:
pixfirewall# sh ver
PIX Version 4.4(1)
Compiled on Tue 18-May-99 16:34 by pixbuild
PIX BIOS (4.0) #0: Tue May 18 16:29:54 PDT 1999
pixfirewall up 2 mins 27 secs
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash strata @ base 0x300
0: ethernet0: address is 0050.54ff.2dd6, irq 10
1: ethernet1: address is 0050.54ff.2dd7, irq 7
2: ethernet2: address is 00d0.b7d4.1962, irq 11
Licensed Options:
Failover: Enabled
IPSec: Disabled
Ports allowed: 6
Serial Number: 480040508
pixfirewall# sh hard
PIX Version 4.4(1)
Compiled on Tue 18-May-99 16:34 by pixbuild
PIX BIOS (4.0) #0: Tue May 18 16:29:54 PDT 1999
pixfirewall up 2 mins 30 secs
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash strata @ base 0x300
0: ethernet0: address is 0050.54ff.2dd6, irq 10
1: ethernet1: address is 0050.54ff.2dd7, irq 7
2: ethernet2: address is 00d0.b7d4.1962, irq 11
Licensed Options:
Failover: Enabled
IPSec: Disabled
Ports allowed: 6
