06-07-2012 10:35 AM - edited 03-11-2019 04:16 PM
Hello all,
In need of some websense and firewall help. We have purchased a new Websense 10000 Appliance and I'm not a hundred percent how to set this up. I see that URL Filtering is a possibility and WCCP can anyone recommend which way to move forward on implementing this?
Do both of these protocols use a span port on the connected switch on the appliance to monitor traffic?
Any help would be much appreciated.....
Thanks,
Dan
Solved! Go to Solution.
06-07-2012 11:14 AM
Hi Dan,
You can refer this doc, it explains everything:
Thanks,
Varun Rao
Security Team,
Cisco TAC
06-07-2012 11:14 AM
Hi Dan,
You can refer this doc, it explains everything:
Thanks,
Varun Rao
Security Team,
Cisco TAC
06-08-2012 07:03 AM
Thank you Varuna, is the pix515 able to use wccp as its redirect?
Thanks,
Dan
06-08-2012 07:52 AM
If you are running Websense, it would be best to use the document the TAC engineer listed above. If you are running version 7.02 or later on the PIX, WCCP is available. WCCP is generally used to redirect traffic to an Ironport device.
06-10-2012 07:26 PM
Does that also include using transparent identification via websense? We are wainting to intergrate it with our active directory so it can pull policy via AD groups. I thought that WCCP was needed for that.
thanks,
Dan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide