On 16th Aug 2020, Cisco has published the latest IOS XE Release- Cisco IOS XE Amsterdam 17.3.1a.
IOS XE 17.3.1a continues to enhance the Enterprise Routing offerings. There are key software feature enhancements covering Licensing, Security, Voice, VPN, Layer 3 and Network Management areas.
New Software Features with IOS XE Release 17.3.1a
Release 17.3.1a will enable key feature enhancements to address various use-cases in today’s network deployments.
Prior to 17.3.1a Smart Licensing log messages were hard to understand. We have improved readability of Smart Licensing error messages in 17.3.1a.
In this release, we are also enabling support for LAN MACSEC for ISR4K. This allows interoperation with Cisco and third-party switches at line rate using 128/256 bit encryption.
We have also done SSL VPN migration from TLS 1.0 to TLS 1.2 for CSR1Kv.
UDLR tunnels enable a router to emulate the behavior of a bidirectional link for IP operations over the unidirectional links (UDL). Return traffic for multicast protocols is required. As part of this release we have enabled configuration of a tunnel for the UDL’s return traffic.
Dynamic Application Policy Routing (DAPR) feature was introduced in IOS-XE 16.11. As part of 17.3.1a release we have address scale requirements, additional platform support (ASR1k, CSR1kv, ISRv) and minimum bandwidth for flow admission.
We have also addressed the scale requirements for PBR interfaces as part of this release. Prior to 17.3.1a, maximum number of supported PBR interfaces were 1024. We have increased this to 30k PBR interfaces. This is only supported on high-end platforms – ASR1009X with RP3, ESP100/200/200x, C8500-12X4QC, C8500-12X.
ePBR support in Office365 traffic categories for DIA has also been improved to support two additional use cases
Match and steer O365 traffic based on traffic category to provide optimal and reliable experience and improve O365 application experience
Enabled on enterprise internet edge to load balance internet traffic across multiple links to provide redundancy and better link utilisation
There are few improvements done on Network Management side as well as part of 17.3.1a release.
ASR1000 MIBS support for all relevant QFP resources in SNMP and Netconf/YANGF372
RPC support for multicast platform specific CLIs
YANG support for “show platform software ipsec policy statistics
There are a number of Serviceability’s also addressed as part of this release.
You will be able to find few additional feature support details on individual platform Release note pages:
Hi! I´m receiving the error Failed to commit one or more configuration items during a pseudo-atomic operation. All changes made have been reverted. Please issue 'show configuration failed [inheritance]' from this session to view the errors.I received this...
Dear all, May I know if the "system mtu jumbo" command will appear in the "show running-config" of a CGS2520 switch please? Or it will be hidden from the IOS config files? Thanks for your attention in advance!
I have a simple scenario as in the diagram:I am advertising a route 220.127.116.11/24 from R4 to AS 100. When I verify BGP table in the R1,R2,R3:R1#show ip bgpBGP table version is 8, local router ID is 18.104.22.168Network Next Hop Metric LocPrf Weight Path* i...
Thought just occured to me as to whether or not I should be able to ping acorss this trunk portswhile doing this lab In doing a HSRP lab between the switches I recognized there needed to be communication between the switches to elect the active...
Hi All I have 2 x Cisco 1140 Fws running in ASA mode. Active/Standby 2 x 9300s with a trunk between ten Cisco have depreciated the Redundant interface on the 1140s I have configured sub interfaces on one of the ports of FWs with ...